KurtUSB Analog Module (4 Port-6 Pin)
Part No. e3

The KurtUSB Analog Module provides direct interface to four analog output type sensors. Up to four analog sensors can be interfaced to the module at one time. The connector used on the Analog module is a six-pin Hirose type connector. Kurt provides pigtail interface cables that have the correct mating connector to the module and a bare-wire pigtail interface for customer interface if desired. Interfaced analog sensors or devices can provide a wide range of input to the analog module as listed below. The module is also capable of outputting up to + 15 VDC. A single footswitch input, available on the module, can also be programmed to collect data when triggered. Using the KurtSPC software, the Analog output can be calibrated to resolve changes in voltage for extremely precise measurement capabilities.

(KurtUSB Base Module required for operation)

Additional Information:
Number of Channels per module: 4 Channels
Input type supported: 0-10VDC, +/-5VDC,
+/-10VDC
Output Voltage: +15VDC
Connectors:
Analog Channels: Hirose HR10A-7R-6S
Footswitch: Female Switchcraft #MDSL2ARA
Footswitch option: Switch Closure
For detailed technical information, see Kurt ICS USB flyer on previous page.

Dimensions
Height X Length X Width
6-1/8” X 3-5/18” X 1-1/4”
Price:  $935.00 
Quantity:
 Write Review
KurtUSB Analog Module (4 Port-6 Pin)
Number of Channels per module: 4 Channels Input type supported: 0-10VDC, +/-5VDC, +/-10VDC Output Voltage: +15VDC Connectors: Analog Channels: Hirose HR10A-7R-6S Footswitch: Female Switchcraft #MDSL2ARA Footswitch option: Switch Closure For detailࢼꃊ૘૘뗐ཾཾꃊ૘�ྂ瀠ź펰盘餈ࢸ펰盘餬ࢸItemࢸCount`ﱬ휴癟탼癠탼癠￿￿￿￿ꅚ૘ñ餬ࢸ藘Ŭ衉쉱 ﰼ䀋